@ MattF

[POPEYE]

OK! first thanks Alekseyev for the comment, much apprecieated

Matt, i got the lower fans fitted now and a bunch of four cables in the bay ready (the ones hanging over the wing) been looking on veh wireing and what relays do suggest, i thought of either fitting four R20 B's 30amp to work each fan or two
R70's 70amp to work two fans each, wotch reccon? also anything else i need to buy, i have plenty of switches, led's etc, looking at your drawing is the parts marked n/c and com the relays? and the top right hand side of the drawing is cut off, i take it that reads permanant feeds? no rush, i've shot me bolt moneywise so untill next little job

Vince!!! thought might like to see where your fans ended up, (well actually one of em,) i used one of yours and one of mine, both five blades, also had to cut the shroud down for it to fit, fired em up and all ok

Also got the sensor switch in after a struggle, some **** has got hammerite in the thread,
Feel safer now the front bars are back on, summat to hold on to should the scoop try and suck me in
http://www.vehicle-wiring-products.e...ays/relays.php

[marky]

Also got the sensor switch in after a struggle, some **** has got hammerite in the thread
Im not surprised

[POPEYE]

Ok found those 70amp relays that apache sent me while mooching about, would they do, two fans each?

[MattF]

Ok found those 70amp relays that apache sent me while mooching about, would they do, two fans each?

Yup. They should be fine Ian. BTW, I'll get you the precise info on that wiring diagram sorted over the next day or two. (Wench has finally made me stop arsing about and get the accounts sorted, so I'll just have to do these first).

[POPEYE]

Yup. They should be fine Ian. BTW, I'll get you the precise info on that wiring diagram sorted over the next day or two. (Wench has finally made me stop arsing about and get the accounts sorted, so I'll just have to do these first).

No worries mate, dont want her blameing me

Im looseing the plot, spent over an hour wondering why the rear spots would'nt work after me wireing em up, wired the relay and fuse holder ages ago, got a reversing light feed to power the relay and sod all happened, i could hear the relay clicking so that was ok, finally realised i had'nt put a fuse in the holder

[MattF]

finally realised i had'nt put a fuse in the holder

PMSL.