If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
That explains a lot,thanks very much. I was confused by the other two brackets
higher up on the bars.I did not realise that the bottom brackets would be sufficient for supporting the whole bull bar. Maybe the truck they came off had been modified in some way to accept them. Anyway, thanks again,i think i will
have another look next week and see if i can get them on.
Your welcome, if you dont have the proper barckets it'd be easy to make some from some heavy gauge angle, ya just need someone to hold em in place while you have a measure up,
Tweet
Comment