Hi Folks - Some connectors and other parts wanted.

[wiggy]

Hi All,
Changed the starter this weekend and discovered a lot of small issues when a garage had been fiddling in the engine bay when they replaced the fuel pump & some other bits.

Ok long and the short of it is that i need some connectors still connected to wiring so i can splice them in as replacements;

1.Temp sender clip (single wire still needs to be connected).
2. Connector (presuming oil pressure sensor), that is about the 3 or 4 o'clock position to the right of the oil filter on the 3.0 (single wire still needs to be connected).
3. VSV 1 & 2 (if possible some of the vac tubing).
4. Connectors for said vac sensors (4 above).
5. Connection for speed sensor (wires still need to be connected).

I do have some pics if they are required & this is a bit of a priority to get sorted, so any help would be greatly appreciated

As always many thanks in advance!

Regards,

Rob

[wiggy]

Bump......

Nobody breaking anymore?

Regards

Rob

[budweiser]

got bits, but of the 2.4

[wiggy]

Hmm...are they the same connectors (pics attached), VSV should be the same? :

[wiggy]

Bump.....

[budweiser]

is it look like this?

[wiggy]

Thanks for the reply but i don't think they are the same judging by the pics but cant quite make them out I have attached another close up below but not feeling to hopeful.

Regards

Rob

[budweiser]

i will check outside the one im breaking see if it got similar of it, when this hailstones finish!!

[wiggy]

Haha thanks!

[budweiser]

sorry i forgot to put this pic up after the bad weather

[wiggy]

Hi All,
Changed the starter this weekend and discovered a lot of small issues when a garage had been fiddling in the engine bay when they replaced the fuel pump & some other bits.

Ok long and the short of it is that i need some connectors still connected to wiring so i can splice them in as replacements;

1.Temp sender clip (single wire still needs to be connected).
2. Connector (presuming oil pressure sensor), that is about the 3 or 4 o'clock position to the right of the oil filter on the 3.0 (single wire still needs to be connected).
3. VSV 1 & 2 (if possible some of the vac tubing).
4. Connectors for said vac sensors (4 above).
5. Connection for speed sensor (wires still need to be connected).

I do have some pics if they are required & this is a bit of a priority to get sorted, so any help would be greatly appreciated

As always many thanks in advance!

Regards,

Rob

Bump........

[wiggy]

Anyone have these knocking around? No breakers or scrappies around here seem to have any surf's in....

Rob