Hi All,
Changed the starter this weekend and discovered a lot of small issues when a garage had been fiddling in the engine bay when they replaced the fuel pump & some other bits.
Ok long and the short of it is that i need some connectors still connected to wiring so i can splice them in as replacements;
1.Temp sender clip (single wire still needs to be connected).
2. Connector (presuming oil pressure sensor), that is about the 3 or 4 o'clock position to the right of the oil filter on the 3.0 (single wire still needs to be connected).
3. VSV 1 & 2 (if possible some of the vac tubing).
4. Connectors for said vac sensors (4 above).
5. Connection for speed sensor (wires still need to be connected).
I do have some pics if they are required & this is a bit of a priority to get sorted, so any help would be greatly appreciated
As always many thanks in advance!
Regards,
Rob
Changed the starter this weekend and discovered a lot of small issues when a garage had been fiddling in the engine bay when they replaced the fuel pump & some other bits.
Ok long and the short of it is that i need some connectors still connected to wiring so i can splice them in as replacements;
1.Temp sender clip (single wire still needs to be connected).
2. Connector (presuming oil pressure sensor), that is about the 3 or 4 o'clock position to the right of the oil filter on the 3.0 (single wire still needs to be connected).
3. VSV 1 & 2 (if possible some of the vac tubing).
4. Connectors for said vac sensors (4 above).
5. Connection for speed sensor (wires still need to be connected).
I do have some pics if they are required & this is a bit of a priority to get sorted, so any help would be greatly appreciated
As always many thanks in advance!
Regards,
Rob
Comment