FRONT HUB & DISC

[marky]

I was trying an attempt in replacing my broken wheel stud. I removed the brake caliper then the small nuts at the end of the shaft also the dust cover & small bolt tried a slide hammer to get it of the shaft but its a no go.
Any ideas guys ???

[rich]

This may help Marky

http://www.toyotasurf.asn.au/techsite/cvjoints.htm

Rich.

[marky]

ok thanks rich. i presume after using the 2 bolts to remove the disk it just pops off ????????????????

[Guest]

ok thanks rich. i presume after using the 2 bolts to remove the disk it just pops off ????????????????

I think you will need to remove the 6 nuts and the cone washers, then undo the wheel bearing nuts to pull off the disk.

Cheers

[marky]

so the bolts will pull off the faceplate then. HAYNES manual is pants

[marky]

TONY i need some advice mate

[TonyN]

who me?

[marky]

yes mate!

[TonyN]

Marky, spray it full of WD40, then try a brass drift on the end of the studs, if they still don't move, a club hammer, applied to the hub between the wheel studs never fails. Just hit it inbetween two studs, then move to the next gap, and work your way round, being careful of the wheel studs. You might have to clump it fairly hard, but they should fly out and hit you in the nuts.

[marky]

TONY i meant getting the hub off mate not nut crushing

[TonyN]

TONY i meant getting the hub off mate not nut crushing

kneel down, they will hit you in the chest then! or do it at eye level..........

[Gizmo]

TONY i need some advice mate

Don't ask Tony!!! He'll just say to use the grinder LOL

[TonyN]

Don't ask Tony!!! He'll just say to use the grinder LOL

pffffffffffffftttttttt........ ....

[Gizmo]

pffffffffffffftttttttt........ ....

I only say in jest Tony...wish I had the info in my head like you and your missus

[marky]

dont upset tony mate