Well the temperature reading is spot on but the issue i have is with the built in volt metre. With ignition lights on it reads 12.5ish volts & once runniing it reads 13.4 - 13.9ish, now the problem comes when you rev the engine or drive "at any speed" the voltage drops to around 9.0 volts & stays there unless i turn the head lights on + full beam then it goes up again but drops off after a few seconds.
WTF is going on, ive checked & double checked the wiring is correct so can anyone shed any light on this please, hoping its something simple but knowing my luck...........
Cheers si.
WTF is going on, ive checked & double checked the wiring is correct so can anyone shed any light on this please, hoping its something simple but knowing my luck...........
Cheers si.
Comment