just a new head and block sleeve completed on the surf (due to both being cracked, head and cylinders 3&4) and there is a slooshing sound when I accelerate coming from the heater matrix when its set to warm/hot. I have flushed the matrix through with the hose and it appears to be fine.
The mech who did the repairs has asked me to put in wynns rad flush for the week and bring it in on sat. Read the bottle and it says 10-20 mins for the flushing and then replace with coolant etc.
Will it cause any damage if I leave the flush in there for a couple of days ?(100miles or so) Or should I go with the directions and put it in Sat morning for the drive to the garage?
Any suggestions ?
Cheers
The mech who did the repairs has asked me to put in wynns rad flush for the week and bring it in on sat. Read the bottle and it says 10-20 mins for the flushing and then replace with coolant etc.
Will it cause any damage if I leave the flush in there for a couple of days ?(100miles or so) Or should I go with the directions and put it in Sat morning for the drive to the garage?
Any suggestions ?
Cheers
Comment