I need to get my chassis, axles, links, bashplates etc prepped for paint and powder coating but not sure whether to go about it the long way of using a wire brush on a grinder and sand paper or bit the bullet and get everything blasted clean for paint.
Has anyone had this done? How much did it cost? and are there any other suggestions for how I can get all the old rust off quickly and easily so I can get on with paint and start to actually rebuild my truck!
Also contemplated a DIY kit ie something like a Sealey SB993 - any advice or experiences of DIY blasting would be appreciated.
Has anyone had this done? How much did it cost? and are there any other suggestions for how I can get all the old rust off quickly and easily so I can get on with paint and start to actually rebuild my truck!
Also contemplated a DIY kit ie something like a Sealey SB993 - any advice or experiences of DIY blasting would be appreciated.
Comment