ball joint spacers

[Growler]

If you are looking for some spacers I have a spare set of 2inch alli ones

[gizgrey]

If you are looking for some spacers I have a spare set of 2inch alli ones

I just ordered a set and the diff and arb spacers aswell,i knew i should of hung off till sunday.

[gizgrey]

From your picture:



It's hard to see if it has BJ spacers fitted to the wishbone or not. The rubber boot is not protruding far enough down to have 2" spacers, but does not sit in the wishbone like standard. 1" spacers, maybe? would need a clearer picture of the upper arm to be sure.
However, I can say you seem to have very little gap between the bumpstop and the lower wishbone. Maybe the torsion bars have been wound down, or have relaxed. You could crank the height up on the bars another inch by the looks of it. If not it would be worth your while cutting the bumpstop rubbers down by about half.

how would i go about cranking up the torsion bars.

[davec170]

I'm too lazy to write out the procedure - you'll see loads of info if you the search button. It's easy though.

[yoshie]

You have a 2" body lift, I know because I fitted it

I also have the 4crawler ball joint spacers that came off the truck in a drawer in the garage.

[Wolfracer]

Okay so who wants to sell me some spacers then?

[yoshie]

Okay so who wants to sell me some spacers then?

Me!

[Albannach]

You have a 2" body lift, I know because I fitted it

I put the front spacers in

[yoshie]

I put the front spacers in

You sure you didn't just drink coffee and point as normal

[Albannach]

You sure you didn't just drink coffee and point as normal

No, I definitely put them in and the bolts. Although, I was back to pointing and coffee by the time the tightening process began.

[Wolfracer]

Me!

Pm me a price then Brian...

[KERRSURF]

aye yoshie, ye can sell 'my' spacers.


You will need to get new bolts for them though, a couple of them got damaged when removing the spacers, alloy and steel don't mix. Best to get some grease or copperslip on the bolt shafts when you re-fit them.

when you fit them I'd reccommend a visit to Pro-Grip in Larbert to make sure the camber/castor is still all ok. Only costs about £45 but well worth it, blokes name is John.

[yoshie]

aye yoshie, ye can sell 'my' spacers.


You will need to get new bolts for them though, a couple of them got damaged when removing the spacers, alloy and steel don't mix. Best to get some grease or copperslip on the bolt shafts when you re-fit them.

when you fit them I'd reccommend a visit to Pro-Grip in Larbert to make sure the camber/castor is still all ok. Only costs about £45 but well worth it, blokes name is John.

I know I can that's why I offered call me on my mobby if you can

Larbet is a bit of a run for John he is 350 miles away

[Wolfracer]

I know I can that's why I offered call me on my mobby if you can

Larbet is a bit of a run for John he is 350 miles away

Think I'd be down to the steel bands if they were out after that distance!

[Wolfracer]

You will need to get new bolts for them though,

What size and length are they?