If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hmmm, tempting. I need some.
Anyone doing them any cheaper on here?
How does fitting these affect where the lower arm sits with regard to bump stops, as mine currently maxed out and touching...
"B.A." Baracus: "Talk to me, talk sense so I can talk back. Not all this jibberjabber like breaking the peace and all that."
www.johnthebuilder.info
Should drop the lower arm by two inches and therefore the bump stop will be that much further away from touching on full compression.
Out of interest what bull bar is that on your avatar?
Cool, thanks.
A Bar is the standard one. It was missing the shiney bits so took off the cross member and replaced it with angle iron, covered with ally chequer plate.
does the job!
here's a bigger pic...
"B.A." Baracus: "Talk to me, talk sense so I can talk back. Not all this jibberjabber like breaking the peace and all that."
www.johnthebuilder.info
You should get your facts right Instead of jumping in with your wooden spoon ......It's not who you think it is ...... That's Neil the guy who owned Outrageous
' You've arrived on a rather special night. It's one of the master's affairs.'
You should get your facts right Instead of jumping in with your wooden spoon ......It's not who you think it is ...... That's Neil the guy who owned Outrageous
A Bar is the standard one. It was missing the shiney bits so took off the cross member and replaced it with angle iron, covered with ally chequer plate.
does the job!
Comment