Arrived !!

[nero279]

does the tjm one have any recovery points ?

ask rodleach or tonyN or spoofer28

[nero279]

if they will go through 5mm plate ian they will be ideal

big question is will they ????

i'm smiling coz i have absolutely no idea

[joker??]

does anyone know ???

[gwh200]

a. i dont know and
b. i dont know

but its no great shakes (and that cone drill should do 5mm plate)

[joker??]

a. i dont know and
b. i dont know

but its no great shakes (and that cone drill should do 5mm plate)

right i will buy it and if it dont do it

[gwh200]

right i will buy it and if it dont do it

please be gentle with me!!

[RodLeach]

does the tjm one have any recovery points ?

hello mate, None on mine. Ive got the TJM T15.

Looking at the picture on Ebay, My bumper has a bit that sits a bit lower then the bottom of your bumper....


hang on, i'll sort somet out with MS paint!!

[RodLeach]

Ok - s$$$$ the paint idea! i cant get it across, but basically you can see a 2nd bracket fitted behind the bumper on mine, thats how it mounts on...

I know that one is a different bumper so it could be a different mount, Dont forget to make the adjustments to compensate with the 2" body lift.

[fatfires]

roughly whittle a piece of wood down to near the hole size bang it into the hole with a hammer cut off just proud of the face of the bumper use hole saw with pilot drill in centre of wood, drill slow with loads of lube and drill out new hole with wooden centre...Ta Da!!!!

[dieselboy]

whats up dave, u no reply to #pm's?

[joker??]

roughly whittle a piece of wood down to near the hole size bang it into the hole with a hammer cut off just proud of the face of the bumper use hole saw with pilot drill in centre of wood, drill slow with loads of lube and drill out new hole with wooden centre...Ta Da!!!!

great idea mate but have ordered step drill bit