Tweet
Thanks for that. Will have a look there. May have come up with a solution though. There's a plastic disc on a stud in two places on the rear of the bar that sits against the bumper when installed and what I am going to do is drill the bumper in these two spots and then install an 8mm nutsert into each hole. These will then be used attach the bar with M8 bolts with a nolathane bush as a spacer.
If anyone else has one of these bars to fit at any time and does not have the brackets then just let me know. I have made brackets and will be fitting this bar tomorrow. If all goes well then I could make more or supply the dimensions and materials needed. Have since thought of another design for the brackets as well so may change a few things on the next lot.
Nev.
If anyone else has one of these bars to fit at any time and does not have the brackets then just let me know. I have made brackets and will be fitting this bar tomorrow. If all goes well then I could make more or supply the dimensions and materials needed. Have since thought of another design for the brackets as well so may change a few things on the next lot.
Nev.
Comment