Now thats what i call 'flex' 10..

[an1mal_69]

front end looks great

the plasma will save days making the bits for the rear, i'd hate to be without one now. my new one cuts up to 1" plate a treat.

Nice.. They shipped a HT PMX65 with the table but it's single phase so I've had to swap for a PMX-45 ..should be here this wk, just need to upgrade my compressor then.

[gary-r]

mines 3 phase as well - thermal dynamics pak master.

best feature on the torch is the spacer, you can use a former for shapes and the spacer leg follows the edge. saves hours of tidying up.

it doesn't need a lot of air - 6 bar is plenty for up to 1"plate with a 90a tip but i'm not sure of the cfm rate. the shop compressors have huge tanks here.

[sv1000spilot]

Post edited for vote