are you looking at my a##e?

[Chillitt]

i have been donated a spoiler!!! (thanks very much david!)
this evening i raced home from work and it went like this..
the before photo...

[Chillitt]

step one..
remove all the clutter and pray the rack will still fit!

[Chillitt]

step two...
take out the panel inside, and fine holes through the reinforcing in about the right place. scratch chin and think 'it cant be that straight forward, can it?? drill veeeeeeeeeeeerry small hole from the inside out, and then check allignment

[Chillitt]

step 3..
work out that it goes on the truck not the rack.
holes drilled do indeed line up, so enlarge them to suit bolts. stand back. clap hands and jump back up on the tailgate and drill the other 2 holes. look inside and notice no wires have been drilled, and bolts line up with 2 more holes in the reinforcing bits. spooky.
those of a nervous disposition, look away now.



now for the wiring..
get tank cutter to suit grommet in drill and make a hoofing great hole in your pride and joy

[Chillitt]

step 4...
stick abit of rust stopping jollop on the holes, a bit of silicon on the contact points, and bolt her up!

bolt the rack back down(delete as applicable)


stand back and clap hands again

[MattF]

Looks good. Nice one.

[da SLUG man]

dude... i just got off a very upsetting phone call and you've made me laugh!!

cheers!!

[That Ruddy Squirrel]

Erm,

iIs it me or are you a few steps short ?

Step 5) remove rear spoiler
Step 6) respray rear spoiler
Step 7) refit rear spoiler
Step 8) Demolish beers as you wallow in pride on a job well done


Trev

[DaveD]

These young Chavs with their spoilers and things...... you'll be fitting go faster stripes next........
Looks good

If you've got an underslung spare...post a pic of full back view please.....

[Chillitt]

If you've got an underslung spare...post a pic of full back view please.....

looking over my shoulder? i know your sort.....



as for the colour, i thought i would get a bit of each on there so i could remain neutral in the colour wars...

[POPEYE]

Nice job Charlie, Well done, Drilling them holes in the virgin paint is a real
nerve tingler, I was the same when i drilled for the light bar, two fags and a cup of tea before i plucked up the nessisary, All you gotta do now is take it off again and spray it grey, Anyway top job make, (i hope you bolted it on nice and securely, you would'nt want anyone creeping up in the wee hours and whipping it off, would you!!! hehe)

[Chillitt]

bolted down nice and tight, and threadlock too.....

[DaveD]

looking over my shoulder? i know your sort.....

Dayum! .....me secret is out............

[Chillitt]

here you go dave

full frontal back end shot!

[Chillitt]

and another..