Exhaust system 2LTE

[AndyLala]

Gentlefolk,

having researched exhausts for my 'toy' till I am sick of it... the general opinion (at least an Australian one) is that one requires a 3" dump pipe from the rear of the turbo to run down and across the gearbox to the gearbox/transfer case mount. From there it should be 2.5" straight through to the rear of the vehicle.

Most of the 'custom exhaust' people can handle 2.5" (63mm) tubing with no problems, a few (very few) can handle 3"...

Only problem now is a replacement flange to mount against the base of the turbo...

So get a gasket, and make one up.... or...

http://www.eng-tek.com.au/product_in...products_id=63

Apparently, this fits the exhaust side of the CT20 turbo...

This should do the trick shouldn't it?

[Chillitt]

we have a fabricator on here somewhere, does any one have a dead turbo they could lend to get some made, maybe?

[TonyN]

Andy, you where asking about the turbos, here's what has what...

2.4 non-EFI ..CT20
2.4 EFI ........CT20
3.0 .............CT12B

The 3.0 looks similar, but not sure.

[AndyLala]

So that Eng-Tek flange should fit, as long as its for a ct20 turbo...

[AndyLala]

FYI: research so far

Toyota Part numbers... (for an Automatic)

Front Pipe 17410-35680 £94.14 + vat
Centre Pipe 17420-35021 £51.97 + vat
Rear Exhaust 17430-3D260 £192.04 + vat

4E0702B Gasket 90917-06041 £2.74 + vat (one required - to turbo)
4E0702C Gasket 90917-06045 £0.93 + vat (two required)

Total including vat £402.73

Milners

Front Pipe 003324 £45.00 + vat
Centre Pipe (flexi) 003323 £49.00 + vat
Rear Exhaust 005139 £115.00 + vat

Gasket 000390 £3.00 + vat (two required)

Total including vat £252.63


Top Gear (Hayes)

Centre pipe and Rear Exhaust 2 1/4" Stainless Steel (custom)
Total including vat £379.00

Centre pipe (flexi) and Rear Exhaust 2 1/2" Stainless Steel (custom)
Total including vat £520.00

Longlife (Carshalton)

Centre pipe and Rear Exhaust 2 1/4" Stainless Steel (custom)
Total including vat £380.00

Front pipe 3" Stainless Steel (custom)
Total including vat £199.00

Front pipe 3" Stainless Steel (custom) and Centre pipe and Rear Exhaust 2 1/2" Stainless Steel (custom)
Total including vat £650.00

[Morr]

Andy,
I may have missed something, but if that flange is for a 1KZ-T which is a 3.0, and your profile shows you have a 2.4, I don't think its likely to fit.

[AndyLala]

Indeed, and according to TonyN its not the same type turbo... so double pants... but it is the closest I have found.

Sounds like an opportunity for a little earner... if anyone want to do the same...?