kzn 185 rear wheel bearings

[gog]

Does any one know how how to press in new wheel bearings onto the half shafts ? I have stripped mine and had a local 4X4 centre refit bearings ABS ring etc.(suspect they used a lump hammer and a bit of scaff!) The result is a nightmare. just to get the whole lot to go together I have had to turn 1.5 mm of the inner abs retaining ring. what i took apart does not tally with drawings from rough trax or the Australian manual that came with the car. any help would be gratefully received. I have pictures of the issues but I can not seem to find a way to post them here.
Thanks for any help in advance.

[G1xer]

Did mine myself . You need a press to push stuff off and back on.
I made up a jig for mine and used a tube with bearing pullers to take off the abs ring then a different jig to push the shafts out..
i meant to take pics but was almost finished by the time i remembered..
There are some vids on youtube that give you an idea of what is involved