Hi all merry Xmas, not sure if the two are related but I recently lifted my k reg surf 2.4td by 2 inches, no probs with the lift apart from the hi/lo selector not going forward all the way but that's another story. But now I seem to be having trouble getting good heat out of the heaters, if I'm above 2000 rpm its ok but not amazin it seems like the water pump isn't man enough to push the water up 2 inches higher, anyone else have this trouble?
Announcement
Collapse
No announcement yet.
2" lift but very poor heaters
Collapse
X
-
Ive got the same problem with mine after a 2 inch lift but i was thinking its my heater matrix blocked. Ive used radiator brackets but still no good. Ill check tomorrow and make sure the brackets are actually lowering the rad and not the wrong way round.Last edited by Gonzo12c; 21 December 2011, 21:18.
Comment
-
Originally posted by Gonzo12c View PostIve got the same problem with mine after a 2 inch lift but i was thinking its my heater matrix blocked. Ive used radiator brackets but still no good. Ill check tomorrow and make sure the brackets are actually lifting the rad up and not the wrong way round.Do you know that, with a 50 character limit, it's
Comment
-
Originally posted by Gonzo12c View PostIve got the same problem with mine after a 2 inch lift but i was thinking its my heater matrix blocked. Ive used radiator brackets but still no good. Ill check tomorrow and make sure the brackets are actually lifting the rad up and not the wrong way round.
Comment
-
Originally posted by zem_41 View PostI will look into lowering it tmrw thanks, but wouldn't the matrix still be higher?Do you know that, with a 50 character limit, it's
Comment
Comment