2nd gen chassis dimensions

[djp_y2k]

Hi guys.

I am trying to find the chassis dimensions for a 2nd gen surf.

Does anyone know where I could find them or someone have them to hand.

Hope someone can help.

Thanks

Dan

[djp_y2k]

Is there anyone who coupld possibly help with this

[stormforce]

what actual dimensions do you want.e.g total length,size of the box sections etc.
If i know what measurements you want i will measure up over the w/end on the breaker for you

[djp_y2k]

not to sure exactly. Sorry to sound stupid.

Basically some one drove into the front passenger side of my truck. Most of the impact was taken into the wheel.

The car is pulling to the left. The engineer from the insurance said the chassis is twisted but is repairable as not that bad.

Still drivable, but want to get it sorted. Have access to a dozer etc to get the job done, just wanted some dimensions so I knew where to pull it back too.

Doubt that helps much though. lol

[TonyN]

i have pickup stuff, not sure its the same, even the IFS pickups.

[stormforce]

i'll measure the width of the chasis tomorrow for you and post back unless someone else post before me

[djp_y2k]

stormforce. That would be much appreciated.

TonyN if you have them could you send them to me.

email address is danpayneuk@yahoo.com.

If they are the same then they will be very handy.

thanks guys

[stormforce]

email sent Dan.Measurement is 697mm outside edge to outside edge on the front end of the chasis

[djp_y2k]

Well it was a tad out. Straightened it a bit, just a little more to make it perfect.

Only thing I have noticed is that the wheel sits about 20mm closer to the arch. As in the bit just in fron of the door.

Is there anything in the suspension or steering which may be bent to cause this.