If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
any good as i called in there last week while in stoke on trent and thought there was not enough lift, looked at £130 one but way to big i am after a lift inbetween a domestic one and a full on commercial one
any pointers
Look in halfrauds the other day and they wanted 80+ for a 3 tonne Quick Lift Jack and if I remember max height is 480 mm
I bought a 2 and half ton halfruads jack - are you saying that it wont lift it? Or shouldnt I go under it?
bit nervous now.. was planning to jack it up an put on axle mounts.
BTW whereabouts on the underside is it safe to jack it up? at which point?
(having said that, done 23,000 klicks in a year and only changed a wiper blade so far, apart from local garage doing oil changes for me)
Cheers
It'll be OK, the surf weighs 2 tons roughly, your not lifting the whole car, just one end at the time!!!
I'd jack under the rear diff to lift the whole rear end, or each end of the rear axle and do one corner at a time if your worried. stands can go under the rear axle, or if they are tall enough under the rear chassis, just in front of lower four link brackets.
The front you can do in the middle again, on the crossmember under the diff, or at each end of it. Axle stands can go on the frame near the antiroll bar mounts, or each end of the front crossmember.
4x4toys.co.uk - Keeping you on and off the road...
It'll be OK, the surf weighs 2 tons roughly, your not lifting the whole car, just one end at the time!!!
I'd jack under the rear diff to lift the whole rear end, or each end of the rear axle and do one corner at a time if your worried. stands can go under the rear axle, or if they are tall enough under the rear chassis, just in front of lower four link brackets.
The front you can do in the middle again, on the crossmember under the diff, or at each end of it. Axle stands can go on the frame near the antiroll bar mounts, or each end of the front crossmember.
Comment