Hi the surf pulled to the left , had the tracking done by 4 wheel laser was a lot better (steering idlers already renewed) so took it back and they put it on the ramp and said that it looked ok i stood underneath and looked at the laser markings on each wheel which was on 6 which i presume is 6mm the front left apparently was 5.5 so he tried to adjust. He undone the tie rod clamps and tried to shift the tie rod tube but it would hardly move i told him to leave alone when he started to damage the tube , ideally he shoud have heated with a torch to free up, may take it back and get the manager to do it not a scrote,what seemed strange even on the first allignment was no chart was looked at for settings i think that it was allset up from the rear axle so that all wheels read the same strange? I note that a lot of posts refer to pulling to the left mine is not bad on straight roads i think by nature most roads have a camber to the left and if you were abroad i would expect to pull to the right,i am coming to the conclusion that the combination of the large tyres and the rear wheel drive the motor will always slightly pull to the left, any comments.
mark.s
mark.s
Comment