Lexurf IV.

[BUSHWHACKER]

What leads did Hiroler get?

Magnecore 8mm.

[Albannach]

Magnecore 8mm.

Any idea where from? I'm struggling to find Magnecore's for less than £200.

[BUSHWHACKER]

Any idea where from? I'm struggling to find Magnecore's for less than £200.

http://www.dcperformance.co.uk/cheap.../mgn-8041.html

[Albannach]

http://www.dcperformance.co.uk/cheap.../mgn-8041.html

Perfect! Do they fit under the covers OK?

[BUSHWHACKER]

Perfect! Do they fit under the covers OK?

Yes, but I think you'll have to do a bit of trimming or remove the plastic seperators between the plugs and where they go accross the top/front of the engine..

[Albannach]

Yes, but I think you'll have to do a bit of trimming or remove the plastic seperators between the plugs and where they go accross the top/front of the engine..

Most excellent. I think we should maybe sticky a supplier's thread at the top of this bit of the forum?

[BUSHWHACKER]

Most excellent. I think we should maybe sticky a supplier's thread at the top of this bit of the forum?

Agreed. Hiroler can get Blueprint parts through his work by the way.

I'll put together a parts/suppliers list and start a new thread.

[Albannach]

I'll put together a parts/suppliers list and start a new thread.

Excellent. Did you remember to do a "Bits to modify/remove/leave" thing?

[BUSHWHACKER]

Excellent. Did you remember to do a "Bits to modify/remove/leave" thing?

On the V8 or the Surf?

[Albannach]

On the V8 or the Surf?

Both really.

[dannyboy77]

This time, yes.
Do you need anything? the shell is going tomorrow.

vince can i have the drivers side part of the dash where the head up goes and a bit either side? of do you need that?

[BUSHWHACKER]

vince can i have the drivers side part of the dash where the head up goes and a bit either side? of do you need that?

No worries, I'll pack it up later.

PM your address again 'cos I haven't got it now.

[hiroler]

Funny you should mention the leads I have just been outside fitting all the covers back on! They do fit if you remove all the old clips and use a few of the new ones, lots of swearing and hey presto they are back on!!

I have also modified the rad hoses as they kept coming loose and dumping the coolant I have used some silicone tubing reenforced with wire to allow it to bend will post some pics tomorrow.

[an1mal_69]

be keeping a beady eye on this build..nice and detailed now Vince

[hiroler]

Oh I also blocked that leaky power steering Acv with a bolt and that seems to have sorted it!