yobit eobot.com

Announcement

Collapse
No announcement yet.

3.0 starting problems

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 3.0 starting problems

    Hi Guys,
    i have got internitant starting problems, parked up outside newsagent to get a newspaper would not restart. nothing, the batteries are fine. eventually got it going on third attempt. exact samething happened this morning. Got a suspicion it may be a switch that stops you starting when in gear? ( i was in park and had the handbrake on) i am a little worried as i am off to Cornwall on Saturday.

    i know you guys can point me in the right direction.
    [SIZE=5]A bad days fishing is better than a good days work[/SIZE]

  • #2
    The engine won't crank over at all unless the transmission is in 'P' or 'N', the neutral start switch cuts power to the starter in any other gear position.

    Could be the fuel primer.
    With the engine off, press the plunger on top of the fuel filter a number of times, after approx five or six pumps you should feel a resistance, if not then a new filter head is required.

    Comment


    • #3
      Originally posted by BUSHWHACKER View Post
      The engine won't crank over at all unless the transmission is in 'P' or 'N', the neutral start switch cuts power to the starter in any other gear position.

      Could be the fuel primer.
      With the engine off, press the plunger on top of the fuel filter a number of times, after approx five or six pumps you should feel a resistance, if not then a new filter head is required.
      Hi Bushwhacker, its not the fuel primer.
      [SIZE=5]A bad days fishing is better than a good days work[/SIZE]

      Comment


      • #4
        Does it crank or not?

        Have you tried starting it in neutral?

        Comment


        • #5
          Its not locking up is it? (cranking then getting stuck?)


          Dum dum dummm...

          Comment


          • #6
            Starter motor contacts get a refurb kit from roughtrax
            SWIFT AND BOLD

            Comment


            • #7
              Originally posted by charvell View Post
              Starter motor contacts get a refurb kit from roughtrax
              As above cost next to nowt

              Comment

              Working...
              X