The flange that bolts the tail pipe to the middle pipe on my exhaust has just snapped off (on the middle bit), it looks like it corroded through. So, looks like I need a new mid section.
Question is however, will there be any problems if I run without the tail section for a few weeks? The end of the pipe as it is, is just over the rear axle, and is pointing up towards the underside of the body, could I risk some form of heat damage?
Other question is, best supplier? It looks like Milners (part # 002796
) is going to be around £100 all in.
There is this one on ebay (I think it's the right part) at £85.50.
Thoughts?
Question is however, will there be any problems if I run without the tail section for a few weeks? The end of the pipe as it is, is just over the rear axle, and is pointing up towards the underside of the body, could I risk some form of heat damage?
Other question is, best supplier? It looks like Milners (part # 002796
) is going to be around £100 all in.
There is this one on ebay (I think it's the right part) at £85.50.
Thoughts?
Comment