Injector washers

[JimL]

Anybody got the EPC out there (mines on the blink due to bad PCmanship)

I need the washer which goes down over the thread, the copper gasket which the injector sits down into, and the smallest washer which the nozzle end butts up to.

Engines a 2LT from God knows when, model is '91 LN130-GJMGT but old 2LTE engine was taken out and a 2LT stuck in there

Its the small nozzle washers especially I'm interested in..

Thanks for anything, parts buffoons too ignorant for words (McCoys of Leixlip)

Jim.

[Guest]

Anybody got the EPC out there (mines on the blink due to bad PCmanship)

I need the washer which goes down over the thread, the copper gasket which the injector sits down into, and the smallest washer which the nozzle end butts up to.

Engines a 2LT from God knows when, model is '91 LN130-GJMGT but old 2LTE engine was taken out and a 2LT stuck in there

Its the small nozzle washers especially I'm interested in..

Thanks for anything, parts buffoons too ignorant for words (McCoys of Leixlip)

Jim.

Jim.

Hope that this helps

Cheers

[gerry mann]

re injecter washers

i have about 100 of them here so will be able to sort you out 01725552008/07836288198.

[JimL]

Thanks Andy, thats the diagram, funny though theres another copper gasket/washer which the lower injector butts up to (about 7mm from the nozzle tip) and I cant make it out on the diagram.

Anyway I've been sorted by local Toyota so thanks for the offer Gerry. The new small washers have twice as much meat on them as the old ones which have worn.