If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Sorry chap, been in A&E....pump seals ordered as per bushwhackers link...not here yet...if that sorts the pump then I'll chance driving to you and weld the sump up after the 19th....fingers crossed.
First part went missing in the post, but the seller sent a new one recorded post straight away. Included a lot of advise on the pump and a schematic...good chap.
Seems to have fixed the leak, full test drive tomorrow...
The test drive never ends....managed to run out of fuel last week. On the up side, the primer works :-)
Still been reading posts on here, but spending a lot of time reading up on welding chassis from scratch and how to build an electric motor controller.
A pile of surf bits to dump in the new year to make space in the garage, might pop an add on here once I've tidied up :-S
How's the pub going, we must come down sometime in new year
Last edited by andyverran; 6 December 2014, 01:06.
Comment