If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
You know the split rubber O-ring doobrie for thermostats? What you need is one of those with an ID of 50mm. Heat proof, good seal. I have an idea forming, but I need to cut a thread on the outside of 50mm tube and have never attempted that on my lathe.
I found that 51mm lamps are about a gnats too small to fit my 6cell maglight.
But with some slight packing they would.......
Probly wouldn't last long but be blinkin bright.......
Never turned threads on any large dia stuff on a lathe before.
Only small stuff at college years ago......
Remember arrows are silent.....................
Don't forget to tell everyone its indestructable as seen on top gear.......
Comment