If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Indeed.
Pic showing Surf's transfer case to transmission adapter fitted to the rear of the Lexus transmission. The transfer case then bolts to that. You can just see the end of the output shaft where I chopped 2" off of it, the transfer case coupling just slides onto the splines.
Indeed.
Pic showing Surf's transfer case to transmission adapter fitted to the rear of the Lexus transmission. The transfer case then bolts to that. You can just see the end of the output shaft where I chopped 2" off of it, the transfer case coupling just slides onto the splines.
Vince is your sump made out of a peice of old kitchen worktop?
You are correct sir. It was the the exact thickness I needed to space the sump away from the relay rod and the header flanges away from the torsion bars, before I fabbed up the engine mounts.
You are correct sir. It was the the exact thickness I needed to space the sump away from the relay rod and the header flanges away from the torsion bars, before I fabbed up the engine mounts.
Oh I see I did'nt have that problem with a 6" lift.
Comment