yobit eobot.com

Announcement

Collapse
No announcement yet.

Dohh

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dohh

    putting the viscos fan back in i dropped it

    i have broken the end off of one of the blades








    Luckily the one off the 2nd gen fitted Panic over
    ' You've arrived on a rather special night. It's one of the master's affairs.'

  • #2
    I love happy endings too.
    The toilet paper ran out today but luckily there was a new roll at arms length.

    Comment


    • #3
      Muppet.

      Comment


      • #4
        Originally posted by BUSHWHACKER View Post
        I love happy endings too.
        The toilet paper ran out today but luckily there was a new roll at arms length.

        Comment


        • #5
          Originally posted by MattF View Post
          Muppet.

          Just for reference matt it it's slightly nearer the rad but still moves freely the blades look like they unbolt so the fans could be swapped as look the same soaking with wd40 atm to see if i can disassemble
          ' You've arrived on a rather special night. It's one of the master's affairs.'

          Comment


          • #6
            Originally posted by BioHazard View Post
            Just for reference matt it it's slightly nearer the rad but still moves freely the blades look like they unbolt so the fans could be swapped as look the same soaking with wd40 atm to see if i can disassemble
            I have a 2.4 fan here already dismantled if you need it.

            Comment


            • #7
              Originally posted by BUSHWHACKER View Post
              I have a 2.4 fan here already dismantled if you need it.

              thanks old bean .........I'll bear that in mind Vince
              ' You've arrived on a rather special night. It's one of the master's affairs.'

              Comment


              • #8
                Originally posted by BioHazard View Post
                the blades look like they unbolt so the fans could be swapped as look the same soaking with wd40 atm to see if i can disassemble
                They are steel into an alloy housing, so the WD40 shouldn't be needed. Just make sure you use the largest snug fit tip and give it a good sharp twist whilst firmly pressing down on the screwdriver to crack the seal between the screw and the housing.

                Comment


                • #9
                  Butter fingers !!!
                  Look out Eastbourne, the Pandas are coming !

                  Comment


                  • #10
                    Originally posted by BioHazard View Post
                    putting the viscos fan back in i dropped it

                    i have broken the end off of one of the blades
                    Luckily the one off the 2nd gen fitted Panic over
                    So ya break things even when ya nowhere near the Plain, Ian !!

                    There's always a Payback .... Just don't expect any warning !!!!
                    Buncefield Burner

                    Comment


                    • #11
                      and the winner of idiot of the week is..................
                      www.overfab.uk

                      Comment


                      • #12
                        Originally posted by surfenstein View Post
                        and the winner of idiot of the week is..................
                        One is tempted to ask if that is a nomination
                        Look out Eastbourne, the Pandas are coming !

                        Comment


                        • #13
                          Originally posted by surfenstein View Post
                          and the winner of idiot of the week is..................

                          You
                          ' You've arrived on a rather special night. It's one of the master's affairs.'

                          Comment

                          Working...
                          X