i fitted the new thermostat to it saturday, and drove it up to the garage to start the repairs.
i left it running for well over an hour from first start, to drive up there, and then left it ticking over for absolutely ages, i mean like 30 odd minutes, and the needle stuck on halfway, and the electric backup fan didnt come on either.
i had the aircon on cold for a bit too as it was a little warm saturday, and the truck has no problems at all.
i think its so good, how the truck has been sat there for almost 4 months, and i got in and started her up 1st time with no hesitation. i think the dual batteries help there though.
feels so good to sit back in those recaros. im looking forward to driving her again.
i'll be making some off road vids with a little setup i have in mind (dash mounted cam)
and i plan to either drive round scotlands highlands, or drive over to norway... or least, drive down to the alps again in her - but this time when there is snow!
i will just need to get valve clearances checked and redone because i can hear a very slight tappet noise, and also i think there is a belt a little too tight - making a whirring noise if you rev it.
ill keep you posted
i left it running for well over an hour from first start, to drive up there, and then left it ticking over for absolutely ages, i mean like 30 odd minutes, and the needle stuck on halfway, and the electric backup fan didnt come on either.
i had the aircon on cold for a bit too as it was a little warm saturday, and the truck has no problems at all.
i think its so good, how the truck has been sat there for almost 4 months, and i got in and started her up 1st time with no hesitation. i think the dual batteries help there though.
feels so good to sit back in those recaros. im looking forward to driving her again.
i'll be making some off road vids with a little setup i have in mind (dash mounted cam)
and i plan to either drive round scotlands highlands, or drive over to norway... or least, drive down to the alps again in her - but this time when there is snow!
i will just need to get valve clearances checked and redone because i can hear a very slight tappet noise, and also i think there is a belt a little too tight - making a whirring noise if you rev it.
ill keep you posted
Comment