I need some bits....

[MudSurfer]

Could those who supply them quote me for some parts, and let me know where I can get some others?

Basically, I'm investing in my truck this year, and would like:

BJ spacers
Coil Spacers (or seats for the LC springs)
New bash plate


Drilled/Vented Discs
Performance pads
Uprated rear brakes
Full OME lift kit and steering damper or Rancho - anything other than ProComp
Full set of bushes (silicone)

I'll be replacing the upper and lower ball joints, steering idler, bump stops and so on myself over the next few weeks...

Is it worth going to X Eng for some of the bits?

[surfenstein]

Could those who supply them quote me for some parts, and let me know where I can get some others?

Basically, I'm investing in my truck this year, and would like:

BJ spacers £90 from tonyN
Coil Spacers (or seats for the LC springs)£100 from me
New bash plate what sort made from what material from £50 upwards.


Drilled/Vented Discs i can do the discs for you.but it may be worth getting new ones and i will drill those.
Performance pads
Uprated rear brakes
Full OME lift kit and steering damper or Rancho - anything other than ProComp
Full set of bushes (silicone)

I'll be replacing the upper and lower ball joints, steering idler, bump stops and so on myself over the next few weeks...

Is it worth going to X Eng for some of the bits?

i can help on some bits

[MattF]

Just as a slight aside, I've got hold of an Aus OME catalogue from a member of another forum, if you want to have a peek at that later. Apparently, even though it is an Oz catalogue, the parts can be easily gotten by their suppliers outside of Oz.

[Apache]

Are you making the discs Mark, or buying in and drilling them?

[surfenstein]

Are you making the discs Mark, or buying in and drilling them?

i can either buy them in and drill or you can supply and i will drill.