If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Not sure why a fuel heater would crack your head though... doubtful! Fuel at 90 deg is hardly gonna change the temperature of a head being fed air from a turbocharger!
Yep that's the one that I bought, then cracked the head on my truck as I didn't burp the coolant system properly. No fault to the heater unit, it was operator error
I ran that off the cigarette lighter, both live and earth. That allowed me to put the switch on the centre console near the etc button. Then I fed the cable to the heater behind the glovebox and into the engine bay.
Make sure you know what you're doing about burping your coolant, otherwise you'll get a knackerd head like me. You may need to lengthen some of the wires too as I was a few inches short on a couple of them, the earth for the switch was one. The way I got the cable from the switch to the unit was to poke a hole in the rubber plug where the rest of the electrics enters the interior on the passenger side with a wire coathanger the when it's through, tie the cable to the end and pull it back through. This site was usful in taking the dashboard and glovebox out http://www.showmesome.info/hilux/workshop/dash3.htm
2 more questions, if you don't mind as electrics is not my thing. How will I know the live and the earth and how long did it take you.
Can't remember the colours of the wires running the cig lighter. But the earth is connected to the underside of the lighter and the positive runs into the back. The job took about a day to do, I work slow. It then 2 more days before the head blew lol
Comment