Tweet
got em made up week end, i found it easier to remove the bumper main brackets from the bumper and bolt em up, 2" lift and the holes are 2"apart centers so hopefully it'll marry up OK,
Also test fitted the rad under where the air con was, just have to plumb it up and fit the fans, then cut the skid plate so it goes over the lot, i had to cut a bit of the bull bar n/s bracket as it was fouling the rad hose, and i stuck a off cut of silicon hose over the bend to stop any chaffing, been better with a rad with a top and bottom spigots at either end long ways as opposed to this one, (from a Golf GTI) but it was the best i could find for a tenner brand new!
Got the snorkel tubes fitted in the wings and the wings back on, starting to look it's old self now,
Also test fitted the rad under where the air con was, just have to plumb it up and fit the fans, then cut the skid plate so it goes over the lot, i had to cut a bit of the bull bar n/s bracket as it was fouling the rad hose, and i stuck a off cut of silicon hose over the bend to stop any chaffing, been better with a rad with a top and bottom spigots at either end long ways as opposed to this one, (from a Golf GTI) but it was the best i could find for a tenner brand new!
Got the snorkel tubes fitted in the wings and the wings back on, starting to look it's old self now,