If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have been offered a 1st gen wrap around bull bar for my 2nd gen. Does anyone know if it will fit straight on or if it will fit with a bit altering, or if it just won`t fit at all!!!!
It`s a couple of hours drive. I think i`ll buy it , then get the mig out. I know i`ll be able to make it fit, it`s just wether it`s worth buying second hand with the extra effort needed.
It`s a couple of hours drive. I think i`ll buy it , then get the mig out. I know i`ll be able to make it fit, it`s just wether it`s worth buying second hand with the extra effort needed.
i would of thought that it would only be the mounting points that would need modding.
Thanks for all the info. It was all in vane, I was bidding on ebay, bids were at £26 until I bid with 45s to go, put a bid of £45 in, then in the last 10s I was pipped by 99p.
Incidentally, I think the answer to the original question is yes (sorry about that). I think Logey swapped his first gen bullbar from someone's second gen a bar.
Comment