If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Does anyone know if the rad cap and thermostat for a 2.4 surf 2nd gen are an off the shelf item from local auto spare shops or is it a milners purchase ?
Thanks guys , have just nipped out and got them both. Will have a go tomorrow
Paul
Morning all surfers,
Could somebody tell me where i will find the thermostat as i am going to attempt to put the new one in , is it the housing that the rad cap is also attatched to ? . Also, any tips / hints i will need to know that will help me.
Cheers
Pop those three bolts/nuts off in the housing just below the rad cap, The
thermostat is in there. If you didn't get a new rubber seal with the 'stat,
be careful taking the old one off. That makes the seal between the two
housing parts. Also remember that the little jiggle valve in the 'stat goes
at the top.
Pop those three bolts/nuts off in the housing just below the rad cap, The
thermostat is in there. If you didn't get a new rubber seal with the 'stat,
be careful taking the old one off. That makes the seal between the two
housing parts. Also remember that the little jiggle valve in the 'stat goes
at the top.
Be gentle with the bolts and nuts. Steel bolts in alloy tend to corrode sometimes and weld themselves together. Clean the bolts after removal with a wire brush and apply a little grease to the threads before replacing. Only a very small amount though.
Comment