cant find somethin

[david306]

I cant find my torsion bars. I am looking to wind them up an inch or so when i get the new millners coil springs and spacers in...


Where doi look ????

Also i have been reading posts, one by Tony saying no mods were needed for a two inch raise...Would this not affect the brake bias thingy, being two inches higher would this not apply less brake force to the rear ???




Oh By the way ...Happy easter...

[stormforce]

I cant find my torsion bars. I am looking to wind them up an inch or so when i get the new millners coil springs and spacers in...


Where doi look ????

Also i have been reading posts, one by Tony saying no mods were needed for a two inch raise...Would this not affect the brake bias thingy, being two inches higher would this not apply less brake force to the rear ???




Oh By the way ...Happy easter...

take a look here http://www.4x4wire.com/toyota/tech/torsion_bars/

[NiftyNev]

I cant find my torsion bars..

You don't have any. If your vehicle details are correct then you have a third generation with coil over front suspension. You'll need springs.

Nev

[spoofer28]

mines a 1990 and i dont have any ajustment on the torsion bars????????

[TonyN]

Yes you do, the adjusters are by the gearbox crossmember.

[TonyN]

I cant find my torsion bars. I am looking to wind them up an inch or so when i get the new millners coil springs and spacers in...


Where doi look ????

Also i have been reading posts, one by Tony saying no mods were needed for a two inch raise...Would this not affect the brake bias thingy, being two inches higher would this not apply less brake force to the rear ???




Oh By the way ...Happy easter...

You can put a 2" spacer between the bias valve mount on the axle. If the adjuster bolt is right down the bottem, you can get all the adjustment you need on the thread.