Front offside stub axle dust seal

[andy_enuff]

Long time no post! Hope everyone is well.

Has anyone got an LN130/KZN130 breaking that would have a dust seal for the front stub axle? Not the hammer in bearing oil seal, it is the seal that sits between the rotor shield and the rear of the bearing casing/ hub+disc.

It is listed as 43511JSEAL, DUST(FOR FRONT AXLE HUB RH) part no. 90313 93002

It is a metal disc approximately 4 inches in diameter with 7 holes in it, with a rubber dust seal in the center.

[BUSHWHACKER]

This one?
http://www.roughtrax4x4.com/?doc=16&cid=146&vid=1318

Whatever it is you're looking for, I wouldn't want a 2nd hand seal.

[andy_enuff]

Unfortunately not - when you remove the hub and are left with the plate behind it that has the air vert in it to deflect air at the disc which is removed with 7 bolts then it is the seperate disc in the middle of that which has the rubber seal on it. I'll grab the EPC diagram when I get home but it is shown in the section for the front knuckle shown above