If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It is a bit scary but the instructions are good and the two main things are to trust the template they give you and to keep the drill horizontal whilst cutting the hole(s). Also don't forget (like I did) that you have to remove the expansion box that sits in the top of the wing before starting to drill
And take your time... don't rush it... No interruptions... and drill the right hole in the right panel...! ('cos i was constantly interrupted... and didn't!)
Have all the bits ready before you start... particularly the stuff to finish the cut metal... make sure you do that real good.
The only tricky bit for me was the brace inside the wing... I had to nip down the road to a friend that had an air compressor and a good selection of cutting tools to trim that bit out.
Other than that, it comes with all the bits, and the instructions are good.
Oh yeah thats the kiddy,now how do I let Mrs sumo that I want one of these............ Angie dearest Roger says that I got to have one of these or else he wont pull you out of any more holes
or
Darling can I have next years xmas pressie now.....
Oh yeah thats the kiddy,now how do I let Mrs sumo that I want one of these............ Angie dearest Roger says that I got to have one of these or else he wont pull you out of any more holes
or
Darling can I have next years xmas pressie now.....
Blame it on me if you want mate - Angie will need a real suspension lift before she can reach to hit me
Comment