ABS actuator

[maxigaz]

Hello everyone! I hope somebody could help me. I installed an kz-te engine, tranny and the whole wiring out of a wrecked 96 hilux-surf into a 96 4runner. Everything is good so far but the abs light on. I checked all the wiring continuity is ok. My guess is the actuator now. Th american actuator has the 5 pipe connection on the top of the actuator. The surf version has two on the side(lines from the brake booster) and three on the top. When I removed it from the wrecked vehicle I didn't check which lines goes where. (Since the plugs are the same my plan was to keep the original one, but now I suspect even if the plug is the same the wires might connceted in different order, like the driver side window switch panel) Could anybody take a peek under the hood and confirm which one is the left/right/rear. (Sorry for my english.)
Thank you.

[maxigaz]

Bump!

[woodwarm]

Think your post may have been lost somewhere


Sure someone will help.

[maxigaz]

Thanks! I hope too...

[andyverran]

ABS...I've heard of this mythical technology...

Good luck fella, none on mine...I wonder if it's in the manual, I'll have a quick look in case.

Is this any use?
https://drive.google.com/file/d/0B17...ew?usp=sharing

Or these:
https://drive.google.com/file/d/0B17...ew?usp=sharing

https://drive.google.com/file/d/0B17...ew?usp=sharing

[maxigaz]

Well not exactly what I was looking for but thank you! However pretty good stuff. I've never seen it before.
What I just need somebody who has a 96+ hilux surf would take a look under the hood and tell me which lines is which on the top of the actuator. Left/right/rear.
Here is the right hand drive surf

and this is the 4runner:


Ofcourse this upload didn't work... but i.f you go "right click, open another window" might work

[maxigaz]

Well, I've found it:

http://www.toyodiy.com/parts/p_J_199...XT_4708.2.html