surf gen 2 spare wheel bracket help :)

[glasshopperus]

Hi I am trying to put a spare wheel braket on to my 2nd gen 92 ssrx surf it has the bolt holes for the carrier but I am not sure if I am missing some pieces or what can any one explane ?

please n thanks

GH

[NiftyNev]

I think you got that bit upside down.

Nev

[glasshopperus]

Well I saw a picture another chap put up on the forum n it showed a dip or hole in the centre of that panel that the key goes in. Does yours ? I'm goin to try n pull it of today

[NiftyNev]

Yeah, you're right. There is a different panel there for the rear carrier.

Nev

[NiftyNev]

http://www.toyotasurf.asn.au/forum/v...+wheel+carrier

Nev

[glasshopperus]

Thanks man !

[s car go]

I've removed the spare carrier,and have the panel you need/want! Fancy a swap??

Regards

Mark

[glasshopperus]

Someone had to to some effort to put a plate and bondo over the indent in the cover so I cleared it out all the bolts were their bolt on job is a bobbin

Thanks a lot GH

[NiftyNev]

I did notice something not quite right with the paintwork there, but didn't think that the panel had been filled in. Pretty obvious now.

Nev

[glasshopperus]

I've removed the spare carrier,and have the panel you need/want! Fancy a swap??

Regards

Mark

Na man I'm good thanks after I pulled the bond and plate out it works just fine.

Thanks Unless is it the same colour?

cheers GH

[glasshopperus]

This is it finished a bit ruff as you can see around the edges but with the wheel on ya can't see.