Announcement

**Albannach** · 8 April 2008, 23:46

Originally posted by Jonny77 View Post

Can anyone tell me what it is supposed to be please.
Ta

If you mean the rear half shafts, the end float is zero. Likewise the proshafts should be zero.

**NiftyNev** · 9 April 2008, 00:12

0.075mm to 0.690mm. Maximum 1mm.

Nev

**Albannach** · 9 April 2008, 00:34

Ooops, or up to 1mm

Mine is way more than that, just waiting for enough time to get it done.

**NiftyNev** · 9 April 2008, 00:40

Adjusting shims are 1.8 and 2.25mm. If you need more then it's time for new bushes.

Nev

**Albannach** · 9 April 2008, 00:44

Originally posted by NiftyNev View Post

Adjusting shims are 1.8 and 2.25mm. If you need more then it's time for new bushes.

Nev

Ah, hang on... Are we talking about the front ones? I meant the rears, the half shafts, they don't have shims. Do they?

**NiftyNev** · 9 April 2008, 01:27

Originally posted by Albannach View Post

Ah, hang on... Are we talking about the front ones?

Yes, because that was the question. I call the rears, axles. They have no endfloat.

Nev

**Albannach** · 9 April 2008, 01:33

Yep, me too. For some reason I assumed the OP was talking about the half shafts, no reason why though.

**Jonny77** · 9 April 2008, 08:54

Yes I meant the front, Thanks for the replies, new bushes it is then!

Drive shaft end float