Kzn185 wheel alignment settings

[Vagrant No2]

I have searched here and Yotatec for the wheel alignment (tracking / geometry ) settings for the 3rd Gen kzn185 with no joy . Has anyone got them ???
I have put all the above (kzn , tracking etc ) incase anyone searches for info again .
Need to get wheel alignment done asap .

[BUSHWHACKER]

Ta dah!

Front:-
Castor (Deg) 0.78 -+ 0.75
Camber (deg) 0.30 -+ 0.75
Toe-in (mm) 2.9 -+ 2
Steering Axix inclination (KPi) deg 12.27 -+ 0.75
Tyre preasure (kPa) 170
Rear:-
Camber (deg) DNA
Toe-in (mm) DNA
Tyre Preasure (kPa) 240
Wheel size Standard 6Jx16/205R16R/F 6PR

[Vagrant No2]

I have seen those settings on here before Vince , but I am not sure they are correct for 3rd gen .
Rob did post some on an attachment photo on a thread but I could not read them clearly to copy.

[BUSHWHACKER]

Oh.

I got them from here...

http://www.toyotasurf.asn.au/techsite/downloads.htm

[Vagrant No2]

Ok then , I will take them tomorrow and see how the Surf sets up.
Thanks for help Vince.

[Bibbs]

Ok then , I will take them tomorrow and see how the Surf sets up.
Thanks for help Vince.

Sorry to drag up an old thread, but how was the outcome?

Are these the correct geo for the Gen3?

[Vagrant No2]

Sorry to drag up an old thread, but how was the outcome?

Are these the correct geo for the Gen3?

I still have not found any bumkin garage that has 21st century tracking equipment to do the set up . Back in London I could have asked several people I know and not paid either !!

[Bibbs]

Okay, well I'll go for these tomorrow when I get new rears. Let you know how I get on.

(new Yoko's went on the front today, and then I saw that the rears were low too)

[Bibbs]

They could only do toe .. and they couldn't get the bolts slackened to do it.

D'oh.

There is a place round the corner, in Fleet, that can do caster/camber and toe. Tehy did my Honda, I might get the bolts slackened and take it down there.

[marky]

Heres a copy for 3rd gen wheel alignment

[Vagrant No2]

Heres a copy for 3rd gen wheel alignment

Marky
Is there any way you could type that sheet out as when I print it I still can not read it .

[Bibbs]

All in Degrees apparently (don't know where that is on the keybord, so used a decimal point)

Settings (Lower Limit .. Upper Limit)

FRONT

Total Toe +0.10 (+0.00 .. +0.19)
Partial Tor +0.05 (+0.00 .. +0.10)
Set-Back +0.00 (-0.36 .. +0.35)
Camber +0.10 (-0.35 .. +0.55)
Caster +2.25 (+1.40 .. +3.10)
King-Pin - NA
Included Angle - NA

REAR

Total Toe - NA
Partial Toe - NA
Camber - NA
Thrust Angle +0.00 (-0.15 .. +0.15)

[marky]

Marky
Is there any way you could type that sheet out as when I print it I still can not read it .

Ive only got the picture as posted by someone else i did print it out and the Tracking guy understood what it was.