Where is the offside rear tie bar bracket ?

[FlySurfer - Edy.]

Apparently got a nut missing but cant find this bit...

anyone know where to look ?

Cheers.

Ron.

[BUSHWHACKER]

Tie bar??? are you sure?? they're normally on the front.

[BUSHWHACKER]

Do you mean the anti-rollbar link/tie-bar?
It's at the end of the anti roll bar in the pic and goes verticaly onto the chassis rail. There should be a nyloc nut on the end.

[FlySurfer - Edy.]

Cheers Bushwacker...

I was told that I had a nut missing off the bracket...offside rear tie bar bracket was what he said...

I'll go check according to your pic...

Be right back...

[FlySurfer - Edy.]

No nuts missing on the bracket so canny be that captain....hmm the search for the nut continues...

[TonyN]

Try the panhard rod, goes across the car, from the axle to a mount on the frame, parallel with the axle.

[FlySurfer - Edy.]

Nope not the pan hard Rod...checked that already as its BIG....

Anything else that could be a tie rod (new term - Tie hard Rod)...that fits to a bracket that could have a nut missing ?

Hope it doesnt do anything unpredictalbe...wish I could get hold of the guy who spotted it too !

Thanks again tho...

[BUSHWHACKER]

Here's all the bars and links for you to check. have a cuppa first tho'.

[FlySurfer - Edy.]

And a Big fat Cuban Cigar too by the looks ! Cheers Bushwhacker....!

[NiftyNev]

My guess is the Stabiliser Bar Bracket has a Bolt missing or more likely snapped off. Bottom left of diagram. These bolt to axle housing.

Nev

[FlySurfer - Edy.]

Here's all the bars and links for you to check. have a cuppa first tho'.

Ahh but no but yeah but nooooo.....

The above diagram does not show the rear anti roll bar.
The nut that he meant was the bracket holding the stabiliser bar on to the axle on the offside side...

infact the whole bracket is missing....

milners ?

[BUSHWHACKER]

The stabiliser/anti-roll bar is in the diagram???!!
Milners should have them, may as well get new bushes as well they're only a few quid.



p.s. It's a bolt that holds the bracket to the axel, not a nut .

[FlySurfer - Edy.]

bligh me...just cant get the staff these days....nuts fer bolts and tie bars for roll bars...

anyway....again many thanks....

Ron.

[Gizmo]

bligh me...just cant get the staff these days....nuts fer bolts and tie bars for roll bars...

anyway....again many thanks....

Ron.

Same here...local garage on MOT talked about the Drag-link....after speaking to them further and looking at the part marked with chalk it ended up being the inner tie-rod

[The Saddlemaker]

My guess is the Stabiliser Bar Bracket has a Bolt missing or more likely snapped off. Bottom left of diagram. These bolt to axle housing.

Nev

maybe the only nut thats missing is the guy who told you!!!!!!
Martin
over the hills and far away,(an stayin here!)