Say hello to my little friend!

[zem_41]

Speed sensor

Hole enlarged

[zem_41]

Speed sensors

Oil hole freshly drilled

[zem_41]

Pic

Bracket

[zem_41]

Inside pic

Pic

[zem_41]

Handbrake relocate

Picture

[zem_41]

Ah brilliant thanks vince for all your help, I can sleep easy tonight again ha!
Although I do have another query if that's ok ?
When you do the handbrake cable mod, what do you do to the bracket on the inside that bolts to the dash board strut?
Thanks buddy

[BUSHWHACKER]

2mm shorter is no problem, you'll still have enough length on the splines to engage the transfer case.

[zem_41]

Cool cheers Vince, I had read that already but it got lost in all the many many others I have read.
So on closer inspection of the output shaft it seems I have not taken into account the thickness of the cutting disk. Now the output shaft is 2mm shorter than the surfs, in your expert opinion do you think this will cause an issue? If so I will have to get the surf one swapped over = expensive I'm sure, but oh well my on silly fault.
Apart from that all is good.

[BUSHWHACKER]

So yesterday and today I got a fair bit done, removed the smelly oily lump from the surf, removed the gearbox and transfer case, cleaned up the engine bay, drilled and tapped the new bolt hole for the gearbox, cut the output shaft down(maybe 2mm too much!), cut the speed sensor and tapped in the 4mm holes for the grub screws,
Quick question for vince, should the speed sensor be as close to the blades as possible or is there a set distance ?
Thanks

http://www.toyotasurf.asn.au/forum/v...ic.php?t=20289

Use threadlock on the grub screws and don't block the tiny oil feed hole on the shaft.

[jmc]

Thanks both; will see what I can stuff in the shed!

[zem_41]

Heavy heavy

[zem_41]

Smelly and dirty

[zem_41]

After the removal

[zem_41]

Update

So yesterday and today I got a fair bit done, removed the smelly oily lump from the surf, removed the gearbox and transfer case, cleaned up the engine bay, drilled and tapped the new bolt hole for the gearbox, cut the output shaft down(maybe 2mm too much!), cut the speed sensor and tapped in the 4mm holes for the grub screws,
Quick question for vince, should the speed sensor be as close to the blades as possible or is there a set distance ?
Thanks

[zem_41]

So far off the ls I have sold
The shiny door handles and shuts
The walnut dash bits
The power steering cooler pipe
The rear drop arms
The bumper
The front n/s shock
The calipers
The cruise controls bits
Sun visors
Clear indicator lenses
Driver side door lock
Just to mention a few
All I did was put an ad on eBay with "breaking" and my mobile number, done this about 3 times.