Say hello to my little friend!

[Sylux]

What level of mechanic would you say you were? And have you had to do any welding?

[zem_41]

Power steering cooler which I got off eBay for £8 from an Alfa as I sold the lexus one

[zem_41]

Exhaust over axle

[zem_41]

Flexi exhaust going round front prop

[zem_41]

Oil pressure and temp senders, these have a tapered thread so I had them all machined, having an engineer working next door is a touch, got all three sensors done with only having to hold a ladder for payment! Happy days

[zem_41]

More zorst, the brackets are a bit slap dash but I wanted them to be adjustable but they work.

[zem_41]

More pics of the zorst

[zem_41]

Update

Been a busy few days, the engine is in and all bolted together, the tank is in, the prop shafts are in, the exhausts are done, gear selector needed extending by 25mm so that's done, got wires to the fuel pump ready, got the oil temp and pressure sensors tapped into the soarer oil filter housing, got the water temp sensor tapped in. Had an issue with the gearbox as when I bolted it together a weld on the flywheel lined up exactly with one of the threaded plates on the torque converter and locked it up so had to slide the box back off to find this problem, what are the odds! Made a filter holder out of the lexus bumper and installed the fuel lines to the filter, brakes are done. The vlovo fan I got off eBay for £7 turned out to b a sucker so I couldn't use it on the rad so I mounted it on the removeable tray underneath so it sucks up cold air from underneath no photos yet as it's still wet. So nearly there but unable to continue as I have no loom:-(
Here's a few photos on where I am.
If you could let me know about loom Vince/bushwacker would be much appreciated buddy thanks

[zem_41]

Any news on the loom Vince?
Thanks

[zem_41]

I have played around with exhaust before but never made a custom one, it's not easy trust me but I'm getting there, having a selection of pre made bends helps a a lot. I will hopefully have it up near the engine bay a bit later so I'll post a few more pics.

[Bazcam]

Looks like you've made a nice job of that exhaust.
I think you may have done this before as its not easy.

I tried to build my own exhaust and failed miserably,
ended up getting a stainless system built.

[zem_41]

Over the axle

[zem_41]

Back boxes in

[zem_41]

Yup

[Ultimagtr21]

GreenStuff pads?