If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
How easy or difficult is it to change the allignment bar? I have a new one, and it says use original clips but i think there too damaged to reuse, what is a good substitute or can i buy them?
If its seized in place you may need to heat it up, split the ball joint of track rod end and put a ring end of a spanner over track rod threads and use that to turn it as a lever.
As regards clamps i dont know
Tweet
Comment