Fubared bumpers

[Fricfrac]

My rear bumpers are knackered, especially the rear quarters. Can I just take the whole lot off or would I have to fabricate a "scaffold bar type" bumper that I have seen on a few pick ups?

Also, quite like the look of the cut down front bumpers. Are these home made or an off the shelf item?

TIA

[Maverick]

You're are fine to remove them.

[MWS]

Also, quite like the look of the cut down front bumpers. Are these home made or an off the shelf item?

TIA[/QUOTE]



Hello Ade. I'm not sure what you mean by "cut down". I did this with mine. It's a cheap and cheerful option. Just trim the valance. It can be done with a Stanley knife, a hacksaw, and a steady hand. It gives much more clearance at the corners, and I quite like the way it looks........

[Fricfrac]

You're are fine to remove them.

Thanks.

Hello Ade. I'm not sure what you mean by "cut down". I did this with mine. It's a cheap and cheerful option. Just trim the valance. It can be done with a Stanley knife, a hacksaw, and a steady hand. It gives much more clearance at the corners, and I quite like the way it looks........

That looks the dogs dangly bits......just need to find somebody with a steady hand now.......

Did you take the valance off or do it in situ?

[MWS]

Thanks.











Did you take the valance off or do it in situ?

In Situ, mate. Piece of cake..........

[Fricfrac]

In Situ, mate. Piece of cake..........

I`ll post the results................

[Overland Tonka]

That trim does look spot on...may check it out myself.