springs

[octo0072000]

springs

Hi John i did the shocks but looks like i need spring compressers to do the springs even with it a foot in the air on highrer than normal car ramps then jack axle on block remove ramps let axle hang chassis on blocks anti roll bar ends off still cant get old springs out found one of my old spring clamps other is lost so get to buy some more on sat then change the springs with just the new rear shocks on it's like a different car so i will be changing the front's when funds allow it passed mot ok but the shockers are 18 years old

[octo0072000]

bits

Hi John
have you any of these bits please for

LN130 2.4 1992

looking for a drivers door handle (plastic cracked) looks like it's been got at and a few more bits

driver door handle

rubber pipe from air filter to plastic pipe over engine to turbo

the rubber curtains on the inner wings that cover engine both sides

fuel primer head

rear heater rubber pipes just above above front end of rear propshaft 2 of

N/S/Front window switch or rear ones are the same

the 2 nuts for front wiper arms and plastic covers


11/ set of wind deflectors all 4

passenger seat base foam rubber and springs so i can repair my drivers side one

let me know what you have and how much please

[JUDWAK]

http://www.owensprings.co.uk/
this is were a lot of springs are made for many cars
no idea if they do hilux springs i have never had to ask yet
but i have had springs from there for lorrys down to 4x4s
and its on my door step

[mud skipper]

Hi John
have you any of these bits please for

LN130 2.4 1992

looking for a drivers door handle (plastic cracked) looks like it's been got at and a few more bits

driver door handle

rubber pipe from air filter to plastic pipe over engine to turbo

the rubber curtains on the inner wings that cover engine both sides

fuel primer head

rear heater rubber pipes just above above front end of rear propshaft 2 of

N/S/Front window switch or rear ones are the same

the 2 nuts for front wiper arms and plastic covers


11/ set of wind deflectors all 4

passenger seat base foam rubber and springs so i can repair my drivers side one

let me know what you have and how much please

great fun getting the springs off without spring compresors. i dissconnected evrything then lift the truck up with a hi lift jack, 4 foot lift to get the springs to dislocate

got all that apart from
1. wind deflectors
2. air box to turbo flexi pipe.


when you say drivers door handle do you mean inside of car and is it just the foam filled bit thats attached to the door card?

£60 sound OK as i will be spliting up a perfectly good seat.
regards
john

[octo0072000]

great fun getting the springs off without spring compresors. i dissconnected evrything then lift the truck up with a hi lift jack, 4 foot lift to get the springs to dislocate

got all that apart from
1. wind deflectors
2. air box to turbo flexi pipe.


when you say drivers door handle do you mean inside of car and is it just the foam filled bit thats attached to the door card?

£60 sound OK as i will be spliting up a perfectly good seat.
regards
john

it's the outer door handle the crome bit you lift to get in it's on a black plastic backing it also includes the keyhole mine is looks like it been got at and the plastic is broken

[octo0072000]

springs

http://www.owensprings.co.uk/
this is were a lot of springs are made for many cars
no idea if they do hilux springs i have never had to ask yet
but i have had springs from there for lorrys down to 4x4s
and its on my door step

i tried to get some coil springs made there they only do leaf springs now they sent me to Don springs at sheffield they will make anything to pattern

[JUDWAK]

i tried to get some coil springs made there they only do leaf springs now they sent me to Don springs at sheffield they will make anything to pattern

i dint know that
i used em many times but it has yes all ways been leaf springs
i'll bare in mind about don springs i know were that is too never used em

were in south yorkshire are ya?

[mud skipper]

it's the outer door handle the crome bit you lift to get in it's on a black plastic backing it also includes the keyhole mine is looks like it been got at and the plastic is broken

no problem, my handles are all OK except the passenger door one.

[octo0072000]

no problem, my handles are all OK except the passenger door one.

like this one if it lets me put ebay link in if not item no 180528941332



ttp://cgi.ebay.co.uk/TOYOTA-HILUX-SURF-2-4-TD-DIESEL-DOOR-HANDLES-/180528941332?cmd=ViewItem&pt=U K_CarsParts_Vehicles_CarParts_ SM&hash=item2a085d0914

let me know when the bits are off and i will pay you thanks

[mud skipper]

like this one if it lets me put ebay link in if not item no 180528941332



ttp://cgi.ebay.co.uk/TOYOTA-HILUX-SURF-2-4-TD-DIESEL-DOOR-HANDLES-/180528941332?cmd=ViewItem&pt=U K_CarsParts_Vehicles_CarParts_ SM&hash=item2a085d0914

let me know when the bits are off and i will pay you thanks

thems tha ones

hopeing to get stripping tomorrow afternoon.
what colour seat are yours?

[mud skipper]

these are mine, a pic from when i stripped and cleaned the interior when i first got it

[octo0072000]

my seats look the same trim but would cost too much to send a seat but by using passengers seat squab on drivers side should make it a bit higher and will have a lot less use than a drivers one you with me on that one

[JUDWAK]

anyhow i have a pit its empty on sundays if you need anywere to do it
iam not much help has iam ill but i have a 40f by 20f unit with a pit bay if you need it dude

[octo0072000]

i dint know that
i used em many times but it has yes all ways been leaf springs
i'll bare in mind about don springs i know were that is too never used em

were in south yorkshire are ya?

me i'm in donny it's tony at don springs cheaper if you say cash and dont take his first price last lot for the delica cost me £70 for a pair 20% uprated

thanks for the offer of the pit i will bare that in mind

[mud skipper]

my seats look the same trim but would cost too much to send a seat but by using passengers seat squab on drivers side should make it a bit higher and will have a lot less use than a drivers one you with me on that one

i'm with you, just thought the cloth maybe of use to you aswell, theres no rips in mine.

i'll get the bits off today
john