general grabbers wont fit!!

[charvell]

my standard tyres were rubbing on the inside edge of the bumper, the springs were shot, sounds like the garage dont have a clue. I changed mine and gave it a 2" inch lift, no more probs

[anthony whatford]

Is it worth a measurement from the back of the bumper to the centre of the hub? Just to see if this is the issue.

its 420 - 430mm

[si tate]

in baildon, where r u?

Odsal

[MudSurfer]

Is it worth a measurement from the back of the bumper to the centre of the hub? Just to see if this is the issue.

[anthony whatford]

Can you show us some pics of your truck, see if there's something obviously wrong.

old tyres are back on so prob wouldnt be much good would it?

[fonecrusher1]

Im running 265/75 r16 on a 3rd gen. I installed 2.5 inch coil spacers recently but even without this mod i was only getting a tiny bit of rubbing.
Just get a cheap body lift from Rtrax? £57 i think for the kit.

[anthony whatford]

Not a clue mate, im in bradford if your near?

in baildon, where r u?

[Albannach]

so whats going on then?

Can you show us some pics of your truck, see if there's something obviously wrong.

[Apache]

3rd gens are non-adjustable. McPherson type struts.

Just noticed the 3rd gen bit...

[si tate]

so whats going on then?

Not a clue mate, im in bradford if your near?

[anthony whatford]

Same as mine or there abouts, 268mm.

so whats going on then?

[si tate]

265mm but I have had to put old tyres back on to get home!

Same as mine or there abouts, 268mm.

[anthony whatford]

Nip out and measure each corner from the bottom of the top edge of the wheel arch to the top edge of the wheel (not the tyre, the wheel rim) and post the figures.

265mm but I have had to put old tyres back on to get home!

[BUSHWHACKER]

100% grabber at2 265/70/16. I have bfg's on the back same size.

Maybe your front bumper has received a knock in the past?

[BUSHWHACKER]

You (or previous owner) haven't suffered saggy ar5e have you, and lowered the front to level it up? They should fit a standard truck...

Wouldn't trust what garages say about these things.

3rd gens are non-adjustable. McPherson type struts.