general grabbers wont fit!!

[anthony whatford]

Time & place?

well got to take my lad for an xray 9.30. so would 11.30 be ok, maplins/halfords carpark?

[Dodge]

100% grabber at2 265/70/16. I have bfg's on the back same size.

Have you tried the BFGs on the front?

[si tate]

that would be good , in the morning?

Time & place?

[Vagrant No2]

Front bumper does look to be abit to far back .
Why did you not just get the new tyres and the rims swopped onto the back and then you could have used the rear tyres and rims on front instead of taking them back off ?

[anthony whatford]

If you have time tomorrow i can meet up & we can measure & compare trucks cos somethings amiss.

that would be good , in the morning?

[si tate]

catches on front, & gets very close to back, a good bump would cause it to hit

If you have time tomorrow i can meet up & we can measure & compare trucks cos somethings amiss.

[anthony whatford]

if the tyre catches on the front then that could well be a possible answer as it does look a little suspect.
i was going to ask him if it catches at the fron or back. this might help if we knew?

EDIT: if you lot think this is strange how about my surf. the front left tyre catches on the mud guard and i have 31"'s on it. 31"'s were an optional extra so obviously designed to fit on ok? but mine doesnt? plus i think its been raised and despite this it STILL catches! lol

catches on front, & gets very close to back, a good bump would cause it to hit

[Albannach]

Did anyone actually read post 16?

I read it, not reading them all now though. I'm getting bored.

[logey79]

stay retired??? wtf have i missed here? don't go mr.hadley, we love you!

[BUSHWHACKER]

Once again vince, you have gone unnoticed.

I knew I wasn't needed on here anymore, I should have stayed retired.

[si tate]

Did anyone actually read post 16?

Once again vince, you have gone unnoticed.

[Bibs]

Did anyone actually read post 16?

Albanach doesn.t read all the posts

[BUSHWHACKER]

Did anyone actually read post 16?

[Albannach]

i run a 3rd gen and it sits a lot higher than that just put new springs an shocks on ride hight went up 1" but it still sat higher think its the shocks an springs ma self works wonders with new ones on

He's already measured the ride hight, it's OK.

[goodcat]

The drivers side bumper looks like it's nudged back a bit in this pic ?

Rob.

Dunno about the 3rd gen but on the 2nd you can loosen off the bumper mounts and wiggle it about to re-position slightly. Maybe that could help.

if the tyre catches on the front then that could well be a possible answer as it does look a little suspect.
i was going to ask him if it catches at the fron or back. this might help if we knew?

EDIT: if you lot think this is strange how about my surf. the front left tyre catches on the mud guard and i have 31"'s on it. 31"'s were an optional extra so obviously designed to fit on ok? but mine doesnt? plus i think its been raised and despite this it STILL catches! lol