Help...!!!!!

[Paul1566]

Right gave the engine bay a good wash sunday, left it till today and now the b00dy thing won't start.....
All the lights come on, press me imobiliser and the batt light comes on but no heater light. She turns over but no glow and no go.......aaarghhhh
Checked fuses ok
Didn't do any rough stuff in the engine bay just squirt some goo and rinse down.

[Paul1566]

Ok just loosened the diesel line to injector 1 and no fuel pumping.....
ECU maybe ?????

[charvell]

mate its got to be just water in a connection you can get electrical contact cleaner from maplin will disperses water. I would go to all the electrical connections un plug them give them a squirt or dry them out ant see what goes

[gwh200]

As charvell says deffo.....as a hunch I would also look at the electrical connections on the back of the pump

[Paul1566]

Pulled off and checked connections blew dry with me supped up bike dryer.
Still no joy.
Going to check power to ECU.

[Albannach]

Did you hose down the inside of the truck, if not then the ECU will be OK (unles it was knackered before).

If you've taken an injector pipe off and there's no fuel whilst cranking, it'll probably be one of the connections on the pump that's got wet.

[TonyN]

if there is no fuel getting to injectors, the next thing back is the spill control valve (on top/back of the fuel pump), you could to take it out, and see if you have fuel to it.

Check you have power to it first, you should be getting 3-6 volts across the two wires with hte ignition on. This will run out the ECU or immobiliser issues if you have.

often the immobiliser turn this off to stop the truck from starting so check the wires on the valve, and on allarm stuff under the bonnet for water ingress.

the factory plugs and sockets are generally very good and water tight.

[Paul1566]

Didn't touch the inside, tried the fault codes by connecting TE1 to E1 but the light did not flash at all ........

[Albannach]

Didn't touch the inside, tried the fault codes by connecting TE1 to E1 but the light did not flash at all ........

That's not right, it should flash (Code 1?).

[TonyN]

That's not right, it should flash (Code 1?).

yeah, continuous single flash for system working ok.

Does the check light come on when you turn the ignition on like normal?

[Paul1566]

Just checked and no engine check light.

[TonyN]

Just checked and no engine check light.

did it have before?

[Paul1566]

yes.
When you open the truck with immob and leave it for a while when you put key in ignition you have to press the fob to deactivate the immob.
This cauases the glow to come on and the engine light to flash and the charge light to come on.
No all it does is light the charge light.

Oh thanks for this guys, its really piddeling me off now so all help appreciated.

[Paul1566]

Well disconnected the ecu for an hour and still no luck.
Been on the oz site and they seem to say ecu fubar.
Well thats the last time i wash me truck if its gunna kill the ecu.

[charvell]

can youdisconect the alarm and imobilser sounds like there the prob